Bending machine equipment has been well applied in many fields. Presumably many people do not know much about the operation and use of this equipment. In order to help everyone understand the correct operation method of this equipment, the personnel of bending machine manufacturers can reduce this aspect. The operation error of this kind of equipment will be explained in detail to you.
Strictly abide by the safety operation rules of the bending machine, and wear labor protection equipment according to the regulations; carefully check whether the motor, switch, circuit and grounding are normal and firm before starting, check that the operating parts and buttons of the equipment are in the correct position; check the upper and lower molds Check whether each positioning device meets the requirements to be processed; when the upper slide plate and each positioning axis are not at the origin, run the back-to-origin program; after the equipment is started, run idly for 1-2 minutes, and then put on the slide plate Full stroke movement 2-3 times, if abnormal sound or fault is found, stop immediately, remove the fault, and work only after everything is normal.
During the work, one person should be under the unified command, so that the operator and the feeding and pressing personnel are closely coordinated to ensure that the cooperating personnel are in a safe position to send the bending signal; Lifting and hurting people; cut off the power supply when adjusting the plate material and press the mold, and stop the operation; when changing the opening of the variable lower mold, it is not allowed to have any material in contact with the lower mold;
When working, no one is allowed to stand at the back of the bending machine; it is strictly forbidden to press and fold the sheet at one end alone; when the workpiece or mold is found to be incorrect during operation, it should be stopped for correction, and it is strictly forbidden to correct by hand during operation to prevent hand injury; it is forbidden to fold over thick Iron plates or quenched steel plates, alloy steels, square steels and plates that exceed the performance of the plate, so as not to damage the equipment; often check the coincidence of the upper and lower molds; whether the indication of the pressure gauge complies with the regulations;
Immediately stop the machine when an abnormality occurs, check the cause and eliminate it in time; before shutting down, place a wooden block on the lower die under the oil cylinders on both sides and lower the upper sliding plate to the wooden block; first exit the control system program, and then cut off the power supply.
The safety operation specification of the bending machine ensures the good operation of the equipment in the future. If the equipment cannot be operated correctly during use, it is likely to cause damage to the equipment, reduce the production efficiency of the equipment, and in severe cases, reduce the output and cause the overall Therefore, in order to reduce or directly avoid this problem, everyone, especially the operator, should understand the safe operation specifications of this equipment.
