To solve and judge whether it’s the valve blocked problems for NC press brake, we need to understand the working principle of the valves first. Here is the explanation:
Check this photo:
There are totally five working lights for the valve group for NC press brake from 100ton to 200ton:
main valve working light we call light 1,
downward valve working light we call light 2,
slow downward working light we call light 4,
fast downward working light we call light 5,
and upward valve working light we call light 5.
Light 1 will always be on as long as machine is working.
We step on foot switch, slider goes down, at this time light 1, light 2, light 3 and light 4 will all be on.
But when slider touches limit switch, and start slow bending of metal sheet, light 3(fast downward valve light) will be off, only light 1, light 2, light 4, will be on.
After we finish bending, slider needs to go up, at this time, light 1, light 5 will be on,other lights are off. When slider gets on the highest position, all lights off.
So let’s make a conclusion, in the whole process of one time bending, it’s light1, 2, 3,4 on, then light 1, 2, 4 on, then light1, 5 on.
Above are the working principle of all the valves, after understanding this, to distinguish which valve is blocked, you need to see which valve light is on but not working.




