One of BEKE 400T4000 53T press brakes was used for 2 years.
Then the Operator found: the X-axis is set to 60mm, but the actual bend becomes 68mm. After checking, we found all the back gauge fingers have this same error. Then we checked the X-axis compensation setting, and it is correct.
So we got the reason is: the operator touches the X-axis finger when using the machine for a long time, and does not maintain the machine regularly. So it has errors. At this time, you only need to go to the internal parameter page of the system and adjust the X-axis reference point. And after restarting, it will return to normal.
BEKE tip:
1.After long-term use, maintain the machine regularly.
① Lubrication: Add grease to the ball screw and linear guide regularly.
② Mechanical fastening: Check if the stop finger fixing screws are loose, and if the timing belt is loose.
2.Simple accuracy check: Move the X-axis to a fixed position many times. Use a vernier caliper to measure the real size to check for errors.











